user-fqdn user-fqdn-name: Uses a user FQDN as the local ID. The user-fqdn-name argument is a
case-sensitive string of 1 to 255 characters, such as adc@test.com. If you do not specify this argument,
the device name configured by using the sysname command is used as the user FQDN.
Usage guidelines
An IKE profile can have only one local ID.
For digital signature authentication, the device can use any type of ID. If the local ID is an IP address that
is different from the IP address in the local certificate, the device uses its FQDN (the device name
configured by using the sysname command) instead.
For pre-shared key authentication, the device can use any type of ID other than the DN.
An IKE profile with no local ID specified uses the local ID configured by using the ike identity command
in system view.
Examples
# Create IKE profile prof1.
<Sysname> system-view
[Sysname] ike profile prof1
# Set the local ID to IP address 2.2.2.2.
[Sysname-ike-profile-prof1] local-identity address 2.2.2.2
Related commands
• match remote
• ike identity
match local address (IKE keychain view)
Use match local address to specify a local interface or IP address that an IKE keychain can be applied
to.
Use undo match local address to restore the default.
Syntax
match local address { interface-type interface-number
| { ipv4-address | ipv6 ipv6-address }
[ vpn-instance vpn-name ] }
undo match local address
Default
An IKE keychain can be applied to any local interface or IP address.
Views
IKE keychain view
Predefined user roles
network-admin
389
To Next Page
Loading...
Need help?
General
