133
Syntax
port-security timer disableport time-value
undo port-security timer disableport
Default
The port silence period is 20 seconds.
Views
System view
Predefined user roles
network-admin
Parameters
time-value: Specifies the silence period in seconds during which the port remains disabled. The value is
in the range of 20 to 300.
Usage guidelines
If you configure the intrusion protection action as disabling the port temporarily whenever it receives an
illegal frame (by using the port-security intrusion-mode disableport-temporarily command), use this
command to set the silence period.
Examples
# Configure the intrusion protection action on port Ten-GigabitEthernet 1/0/1 as disabling the port
temporarily, and set the port silence period to 30 seconds.
<Sysname> system-view
[Sysname] port-security timer disableport 30
[Sysname] interface ten-gigabitethernet 1/0/1
[Sysname-Ten-GigabitEthernet1/0/1] port-security intrusion-mode disableport-temporarily
Related commands
• display port-security
• port-security intrusion-mode
To Next Page
Loading...
Need help?
General
