EasyManua.ls Logo

HP 6125XLG - Page 184

HP 6125XLG
383 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
174
a. Encapsulates the PIM protocol packet of the private network into a public network multicast
data packet. PE 1 does this by specifying the source address as the IP address of the MD
source interface and the multicast group address as the default-group address.
b. Sends the multicast data packet to the public network.
For other PE devices that support VPN instance A as default-group members, PE 1 of VPN instance
A initiates a flood-prune process in the entire public network. A (11.1.1.1, 239.1.1.1) state entry
is created on each device along the path on the public network. This forms an SPT with PE 1 as the
root, and PE 2 and PE 3 as leaves.
2. At the same time, PE 2 and PE 3 separately initiate a similar flood-prune process.
Finally, three independent SPTs are established in the MD, constituting a default-MDT in the
PIM-DM network.
Default-MDT establishment in a PIM-SM network
Figure 61 Default-MDT establishment in a PIM-SM network
As shown in Figure 61, PIM-SM is enabled in the network, and all the PE devices support VPN instance
A. The process of establishing a default-MDT is as follows:
1. The public network interface of PE 1 initiates a join to the public network RP by specifying the
multicast group address as the default-group address in the join message. A (*, 239.1.1.1) state
entry is created on each device along the path on the public network.
2. At the same time, PE 2 and PE 3 separately initiate a similar join process.
Finally, an RPT is established in the MD, with the public network RP as the root and PE 1, PE 2, and
PE 3 as leaves.
3. To establish PIM neighboring relationships with PE 2 and PE 3 through the MTI in VPN instance A,
PE 1 does the following:
a. Encapsulates the PIM protocol packet of the private network into a public network multicast
data packet. This is implemented by specifying the source address as the IP address of the MD
source interface and the multicast group address as the default-group address.
b. Sends the multicast data packet to the public network.

Table of Contents

Other manuals for HP 6125XLG

Related product manuals