228
Figure 70 Network diagram
Configuration procedure
1. Assign an IPv6 address and prefix length to each interface according to Figure 70. (Details not
shown.)
2. Configure Router A:
# Enable IPv6 multicast routing.
<RouterA> system-view
[RouterA] ipv6 multicast routing
[RouterA-mrib6] quit
# Enable MLD on Ten-GigabitEthernet 1/1/5.
[RouterA] interface ten-gigabitethernet 1/1/5
[RouterA-Ten-GigabitEthernet1/1/5] mld enable
[RouterA-Ten-GigabitEthernet1/1/5] quit
# Enable IPv6 PIM-DM on Ten-GigabitEthernet 1/1/6.
[RouterA] interface ten-gigabitethernet 1/1/6
[RouterA-Ten-GigabitEthernet1/1/6] ipv6 pim dm
[RouterA-Ten-GigabitEthernet1/1/6] quit
3. Configure Switch A:
# Enable MLD snooping globally.
<SwitchA> system-view
[SwitchA] mld-snooping
[SwitchA-mld-snooping] quit
# Create VLAN 100, and assign Ten-GigabitEthernet 1/1/5 through Ten-GigabitEthernet 1/1/8
to the VLAN.
[SwitchA] vlan 100
[SwitchA-vlan100] port ten-gigabitethernet 1/1/5 to ten-gigabitethernet 1/1/8
# Enable MLD snooping, and enable dropping IPv6 unknown multicast data for VLAN 100.
[SwitchA-vlan100] mld-snooping enable
[SwitchA-vlan100] mld-snooping drop-unknown
Source
Router A
MLD querier
Switch A
Receiver
Receiver
Host A
Host B
Host C
1::1/64
XGE1/1/8
XGE1/1/6
XGE1/1/7
XGE1/1/5
XGE1/1/5
2001::1/64
XGE1/1/6
1::2/64
VLAN 100
To Next Page
Loading...
