HP 6125XLG - Page 334

324
Figure 101 Network diagram
Table 21 Interface and IPv6 address assignment
Device Interface IPv6
address
Switch A VLAN-interface 100 1001::1/64
Switch A VLAN-interface 101 1002::1/64
Switch B VLAN-interface 200 2001::1/64
Switch B VLAN-interface 101 1002::2/64
Switch B VLAN-interface 102 2002::1/64
Switch C VLAN-interface 102 2002::2/64
Switch C VLAN-interface 103 3001::1/64
Switch C Loopback 0 6001::1/128
Switch D VLAN-interface 300 4001::1/64
Switch D VLAN-interface 400 5001::1/64
Switch D VLAN-interface 103 3001::2/64
Source 1 — 1001::2/64
Source 2 — 5001::2/64
Receiver 1 — 2001::2/64
Receiver 2 — 4001::2/64
Configuration procedure
1. Assign an IPv6 address and prefix length to each interface according to Figure 101. (Details not
shown.)
2. Configure OSPFv3 on the switches in the IPv6 BIDIR-PIM domain to meet the following
requirements: (Details not shown.)
{ The switches are interoperable at the network layer.
{ The switches can dynamically update their routing information.
Source 1 Source 2
Host A
Receiver 1
Switch A
Vlan-int101
Vlan-int101
Vlan-int102 Vlan-int102
Vlan-int103
Vlan-int103
Vlan-int100
Vlan-int200
Vlan-int3
00
Vlan-int400
Switch D
Switch C
Switch B
Host B
Receiver 2
Loop0
IPv6 BIDIR-PIM