Model
83522A
General Information
Table
1-2.
Supplemental Performance Characteristics for Model
83522A
Installed in Model
8350A
(2
of
2)
Spurious Signals (in dB below carrier)
Pulse In
Harmonics: 0.01 to 2.4 GHz
TZTL compatible; Logic HIGH=RF ON
At specified maximum
Logic
LOW=RF OFF
leveled power, typically:
125 dB
Square Wave modulation up to
30
kHz is
At power level of
allowable.
+lo dBm, typically: 230 dB
Non-Harmonics at
External FM
specified maximum
Sensitivity (switch selectable)
leveled power, typically:
130 dB
FM Mode: Typically -20
MHzN
Phase-Lock Mode: Typically
-6
MHz/V
Impedance:
50 Ohms
Input Impedance: 2000 Ohms nominal
Power Sweep5
CRYSTAL
MARKER^
(Operation when RF power set
Accuracy (including linearity):
between
+3 to +13 dBm and 510 markers per sweep)
Typically
t
1.0 dB
Accuracy of Center Frequencies (at
25OC):
f
5~10-~
Resolution (displayed): 0.1 dB
Typical Marker Width Around Center Frequency
1 MHz Markers:
f
100 kHz
Slope Compensation5
Linearity: Typically <0.2 dB
10 MHz Markers:
f
200 kHz
50 MHz Markers:
+300 kHz
Calibrated
~an~e:~ Up to 5 dB/GHz; Up to 15 dB
for full sweep range
External Markers:
f
300 kHz
Resolution (displayed): 0.01
dB/GHz
Temperature Stability:
Typically
t2X10-~/"~
MODULATION CHARACTERISTICS~
GENERAL CHARACTERISTICS~
External AM
External Marker Input:
Generates amplitude or Z-axis
marker when sweep frequency equals external
Frequency Response: Typically 100 kHz
input frequency.
Input Impedance: Approximately
1OK Ohm
Frequency Range:
0.01 to 2.4 GHz
Range of Amplitude Control:
Frequency Reference Output:
IVlGHz
+
25
mV
(over
Typically 15 dB
full sweep range) rear panel
BNC
output.
Sensitivity: Typically 1
dB/V
Weight:
Net 4.5 kg (10 lb.), Shipping
7.7
kg
(17 lb.)
FOOTNOTES
Unless otherwise noted, all characteristics are at the
RF
OUTPUT connector and at 0" to 55°C.
2~ccuracy when calibrated using internal crystal markers and FREQ CAL adjustment.
With respect to the SWEEP OUT voltage.
4~ith Option 002, in power sweep or slope functions, power can exceed attenuator step by 5 dB.
Power Sweep and Slope Compensation must not exceed
15
dB.
6~xternal marker input power typically between -10 dBm and 4-10 dBm (over limited power range).
+
To Next Page
Loading...
Need help?
General
