7.
BASIC
and
HP-UX assume slot 4 (select
code
4) as the default location of a
HP
97060A
interface
but
any
slot may
be
used. If your interface card
is
already installed the way you
want
it,
skip to step 11.
8.
Orient the card so that the connector
is
facing into the card cage
and
is
on
the right side of the
slot. Holding the interface card by
its
ejectors, slide the card into
its
slot.
9. To seat the card, push firmly
on
the ejectors of the card with your thumbs. The ejectors
should be flush with the edge of the interface card.
10.
Connect
the interface cable to the female connector
on
the interface card.
The
cables feed
out
the right side of the card cage door.
11. Close the interface card cage door.
Push
in
and
turn the thumbscrews clockwise until they
are tight.
12.
If you have a Model 520, shut the cosmetic door.
13.
Unpack
and
set
up
your monitor
near
your computer.
See
the monitor's documentation for
more instructions.
14.
Unpack the
HP
97060A
Graphics Processor
and
set
it
near your computer.
15.
If you intend to use
an
HP
9111A Data Tablet with your system, also set that up.
One
common
configuration
is
to place the tablet directly
in
front of the monitor.
16. When the equipment
is
in
place, connect the GPIO interface cable to the connector
in
back.
This connector
is
labelled "J9/GPIO HOST". The connector only
fits
one
way so
if
you have
trouble attaching
it,
check
its
orientation.
17.
Connect
one
of the
1.8
metre BNC cables from the red signal output jack of the Processor to
the red signal input jack of the monitor. The Processor's jack
is
labelled "J1 RED".
Check
your monitor's documentation to determine which input jack to use.
18.
Use the other two BNC cables to connect the green
and
blue jacks
in
a similar manner.
19. The video signal must
be
terminated with
75ft
To
do
this, check your monitor to
see
if
it
has
a
75fl/HI IMPEDANCE switch
or
switches.
Set
it
to
75ft
Some
monitors
do
not have this
kind of switch.
In
this case, check the monitor's documentation.
20. If you intend to use the HP 9111A Data Tablet, connect
an
HP-IB cable from the Data Tablet
to the input jack
on
the Processor labelled "J10IGPIB TABLET". Ensure that the Data
Tablet's device address
is
set to
6.
Ensure that
no
other interface cable
is
connected to the
Data Tablet.
CAUTION
ENSURE THAT THE PROCESSOR
IS
CONFIGURED
TO
MATCH
THE
INPUT LINE VOLTAGE.
21. Now connect the power cords to the Processor
and
monitor
and
optionally to the Data
Tablet.
22. Turn
on
your computer, your Processor, monitor
and
Data Tablet.
23.
If
you
have a Model 520, load the SYSTEM INTEGRITY TESTS system into your
computer
and
run the
HP
97060
test.
24. Adjustment of your monitor's horizontal or vertical hold may
be
necessary to get a stable
picture.
If so,
see
the monitor's documentation for instructions.
5
To Next Page
Loading...
