Messages
Error
Code
#24
Error
Code
#25
Error
Code
#2
Error
Code
#4
Error
Code
#5
Error
Code
#6
Testing
and
Troubleshooting
3-11
Loa
d e r
)O(){
- Informational message identifying the revision of the system loader.
This message
is
usually followed by a single line message identifying the operating
system the computer
is
attempting to load.
T
est
in
9
Me
ITI
0
r}'
t t t - Informational message that follows the "Loader
XXX"
mes-
sage indicating that the loader
is
performing memory tests
and
configuring memory.
This can take up to 15 seconds.
(NOT
AN
ERROR)
L
00
f\
in
9
for
S}'
s t e
ITI
t t t - Informational message that follows the "Testing Mem-
ory ... " message indicating that the loader
is
searching for
an
operating system.
PIe
as
e
ITIO
un
t n
ext
v 0
lu
ITI
e t - Informational message. The loader
is
ready to load
another portion of the operating system. Mount the volume containing an unloaded
portion of the operating system. Volumes may be mounted
in
any order without
affecting the loading process.
SYSTEM
NOT
FOUND;
WILL
RETRY:
XXX
SYSTEM
NOT
FOUND;
WILL
RETRY
IN
XXX
- Unable to find an operating system on any mass storage device. The loader
will
attempt to find an operating system again
in
XXX seconds. Possible causes: mass
storage device not powered up, no media
in
mass storage device, wrong disc
in
disc
drive, computer or mass storage device hardware failure, media failure, incompati-
ble loader/system revision numbers, etc.
BAD
SYSTEM
FILE:
NNNNN
BAD
SYSTEM
FILE:
SELECT
CODE
NN
- Operating system loaded. However, an error has
been
detected
in
the operating
system code during loading.
Possible causes: corrupt system, media failure, mass
storage hardware failure, or computer hardware failure.
INSUFFICIENT
USABLE
MEMORY:
XXXX
NOT
ENOUGH
USABLE
MEMORY;
TOTAL
IS
XXXX
- The amount of usable memory
is
too small to load the operating system. The
total amount of good memory
is
"XXXX" bytes. However, the
amount
of memory
available for the Rev. A operating system
is
"XXXX" minus 32K bytes. The
amount
of memory available for the Rev. B operating system
is
"XXXX" minus
98
304
bytes. Possible causes: corrupt system or hardware (memory) failure.
BAD
CARD
OR
DEVICE:
NNNNN
BAD
CARD
OR
DEVICE:
SELECT
CODE
NN
- Informational message. A hardware failure has
been
detected (interface card
or
mass storage device did not pass the Module Self-Test). The loader continues
searching for
an
operating system. Possible causes:
bad
interface card or mass
storage device.
To Next Page
Loading...
