3-12
Testing
and
Troubleshooting
Error
Code
#9
Error
Code
#11
Error
Code
#12
Error
Code
#13
Error
Code
#14
Error
Code
#15
Error
Code
#16
Error
Code
#17
Error
Code
#18
DEVfCE
NOT
READY:
NNNNN
VOLUME
NOT
MOUNTED:
NNNNN
MEDIA/DEVICE
NOT
READY:
SELECT
CODE
NN
- While loading, the media (Volume) was removed from the device (e.g. a floppy
disc was pulled out of a disc drive), the device went offline, or a hardware problem
caused the device to become
"not
ready".
DMA
FA
I
LED:
NNNNN
- Data did not transfer properly from the mass storage device
to the computer.
Possible cause: Mass storage device hardware failure or computer
hardware failure.
UNRECOVERABLE
DATA:
NNNNN
UNRECOVERABLE
DATA:
SELECT
CODE
NN
- Part of the operating system
is
not readable. Possible causes: media failure or
mass storage device hardware failure.
END
OF
VOLUME:
NNNNN
END
OF
VOLUME:
SELECT
CODE
NN
- Attempt to address or read past the
end
of a volume. Possible causes: corrupt
system, media failure or mass storage device hardware failure.
CTRLR/UNfT
FAULT:
NNNNN
CTRLR/UNIT
FAULT:
SELECT
CODE
NN
- Hardware passed initial self-test. However,
it
failed while being used to load the
operating system.
Possible causes: computer (interface card) hardware failure or
mass storage device hardware failure.
10
TIMEOUT:
NNNNN
10
TIMEOUT:
SELECT
CODE
NN
- Mass storage device failed to respond fast enough while attempting to load from
it.
Possible cause: computer hardware failure or mass storage device hardware
failure.
CS80
DEVICE:
NNNNN
CS80
DEVICE:
SELECT
CODE
NN
- Indicates a mass storage device hardware failure.
TAPE
DEV
I
CE:
SELECT
CODE
NN
-Usually indicates a tape device (HP 7970, HP
7974, HP 7978) hardware failure. Can also indicate a failure on the HP 27110A
HP-IB
Interface (or the Internal HP-IB interface). Tape errors covered are:
"Com-
mand Rejected", "Interface Busy", "Rewinding", "Tape Runaway", "Data Timing
Error",
and
"Command
Parity Error".
HPIB
CARD:
NNNNN
HPIB
CARD:
SELECT
CODE
NN
- Transaction to the indicated HPIB interface card was terminated due to a prob-
able interface card failure.
BAD
10
BUS:
NNNNN
BAD
10
BUS:
SELECT
CODE
NN
- Indicates a computer hardware failure on the computers
first
lOP.
To Next Page
Loading...
