Assembly
Access 4-11
Ac Power Cord
WARNING
AFTER REPLACING THE AC POWER CORD, PERFORM CON-
TINUITY
TEST BETWEEN POWER CORD GROUND AND METAL
CHASSIS.
RECORD RESULTS ON
REPAIR
ORDER.
1.
SET THE POWER SWITCH ON THE
REAR
PANEL TO THE
"0"
POSITION AND DIS-
CONNECT
THE
AC
POWER CORD FROM THE WALL OUTLET.
2. Remove both front panels
and
the flip-top panels as previously described (HP
9040
only).
3.
Remove top cover from System
II
enclosure as previously described.
4.
Remove the
110
lid
by releasing the power supply cable from the cable clamp
and
removing
the four
#2
Pozidriv screws that attach the
110
lid
to the chassis.
5.
Remove the two nuts that attach the terminal block cover to the rear panel
and
remove the
cover.
6.
Disconnect the three line cord wires from the terminal block.
7.
Snap
out
the line cord strain relief from the rear panel,
and
pull out line cord.
WARNING
THE REPLACEMENT CORD MUST HAVE THE SAME POLARITY
AS THE ORIGINAL. OTHERWISE, A SAFETY HAZARD FROM
ELECTRICAL SHOCK MIGHT EXIST WHICH COULD RESULT IN
INJURY
OR
DEATH TO PERSONNEL.
To Next Page
Loading...
