HP A5120 EI Series

4
Installing the switch
CAUTION:
Keep the tamper-proof seal on a mounting screw on the chassis cover intact, and if you want to open
the chassis, contact your HP Support for permission. Otherwise, HP shall not be liable for any
consequence caused thereby.
Figure 1 Hardware installation flow
Start
Install the switch to a 19-in
rack or workbench
Ground the switch
Connect the power
cord
Verify the installation
Power on the switch
Operating properly?
Power off the
switch
Troubleshoot
the switch
Install interface cards?
Yes
Yes
No
No
Install interface cards
Operating properly?
Yes
No
Troubleshoot
the switch
End
Connect transceiver
modules, connectors, and
cables