HP A5120 EI Series

32
6. On the Settings tab (Figure 37), set the emulation to VT100 and click OK.
Figure 37 Setting terminal emulation
Powering on the switch
Verification before power-on
Before powering on the switch, verify that:
 The power cord is properly connected.
 The input power voltage meets the requirement of the switch.
 The console cable is connected correctly.
 The console terminal is powered on and configured correctly.
Power-on sequence
The A5120-24G-PoE+ EI TAA (2 slots) switch is used in the following example.
The power-on sequence is as follows:
1. Power on the switch. The console terminal screen displays the following information:
Starting......
********************************************************************************
* *