HP Compaq d330 DT Troubleshooting Guide

Troubleshooting Guide www.hp.com 2–31
Troubleshooting Without Diagnostics
Network controller stops
working without apparent
cause.
The files containing the
network drivers are
corrupted.
Reinstall the network drivers, using
the Restore Plus! CD.
The cable is not securely
connected.
Ensure that the cable is securely
attached to the network connector
and that the other end of the cable
is securely attached to the correct
device.
The network controller is
defective.
Contact an authorized service
provider.
New network card will
not boot.
New network card may be
defective or may not meet
industry-standard
specifications.
Install a working, industry-standard
NIC, or change the boot sequence
to boot from another source.
Cannot connect to
network server when
attempting Remote
System Installation.
The network controller is
not configured properly.
Verify Network Connectivity, that a
DHCP Server is present, and that
the Remote System Installation
Server contains the NIC drivers for
your NIC.
System setup utility
reports unprogrammed
EEPROM.
Unprogrammed EEPROM. Contact an authorized service
provider.
Solving Network Problems (Continued)
Problem Cause Solution

HP Compaq d330 DT Specifications

General

Brand	HP
Model	Compaq d330 DT
Category	Desktop
Language	English