Installing Hardware Options
Table 3-1: System Board Connectors and Components continued
Location Component Location Component
13 CD-ROM/diskette or
DVD/diskette connector
17 Processor socket (populated)
14 ATA controller (primary) 18 Remote Insight Lights-Out
Edition II connector
15 Center wall fan connectors 19 NMI debug button
16 Processor power connector 20 DIMM sockets (1-4)
Installing Additional Memory
Server memory can be expanded by installing Double Data Rate Synchronous
DRAM (DDR SDRAM). The system supports up to four PC2100 ECC registered
DDR SDRAM Dual Inline Memory Modules (DIMMs) installed in four sockets on
the system board. Memory can be added one module at a time.
Refer to Figure 3-4 and to Table 3-1 for DIMM slot location and socket numbers.
This information is also available on the hood label.
The server memory can be expanded to 4 GB. In the maximum memory
configuration, all four DIMM sockets are populated with 1-GB, PC2100 ECC
registered DDR SDRAM DIMMs.
Observe the following guidelines when installing additional memory:
•
•
•
•
•
DIMMs installed in the server must be PC2100 registered DDR SDRAM, 2.5 V,
64 bits wide, and ECC.
All DIMMs installed must be the same speed. Do not install DIMM modules
supporting different speeds, for example, 266 MHz and 200 MHz.
Install the DIMMs in descending sequential order, starting with DIMM socket 4.
Use only HP recommended DIMMs. DIMMs from other sources can adversely
affect data integrity
Use only the 3.05 cm (1.2 inch) DIMMs.
HP ProLiant DL320 Generation 2 Server Setup and Installation Guide 3-7
HP CONFIDENTIAL
Writer: Anna Roberts File Name: d-ch3 Installing Hardware Options.doc
Codename: MoonStar Part Number: 293166-002 Last Saved On: 1/31/03 11:16 AM
To Next Page
Loading...
