RAID Configuration and Management
Using the Configuration Utility
After all hard drives have been installed and connected, press the F8 key during
startup to run the Integrated ATA RAID Configuration Utility and view the setup
screen.
IMPORTANT: If the configuration utility setup (F8) is not run, the option ROM will
automatically configure the drives to individual RAID 0 arrays.
The setup screen has three menu windows:
•
•
•
Array Information
Physical Drive Information
Help Information
Array Information
IMPORTANT: Drives cannot be added or removed from an array that has already been
configured without destroying the data present on the already configured array.
The Array Information window of the setup screen displays all the drive arrays
configured. Use this window to create, delete, or edit the existing configurations.
Press the up arrow and down arrow keys to navigate the properties, and then press the
Enter key to edit your selection. Additional arrays can be created in this window.
Refer to Chapter 2 of the HP ProLiant DL320 Generation 2 Server Maintenance and
Service Guide for more information.
NOTE: To add additional arrays, follow the onscreen steps after an array configuration is
selected. Refer to “Help Information” for more information about arrays.
Physical Drive Information
The Physical Drive Information window displays all the physical drives connected
to the ATA/100 controller channels and their properties. Press the up arrow and down
arrow keys to navigate this window. This window is not editable.
6-4 HP ProLiant DL320 Generation 2 Server Setup and Installation Guide
HP CONFIDENTIAL
Writer: Anna Roberts File Name: g-ch6 RAID Configuration and Management.doc
Codename: MoonStar Part Number: 293166-002 Last Saved On: 1/31/03 11:19 AM
To Next Page
Loading...
