Regulatory Compliance Notices
A-8 HP ProLiant DL320 Generation 2 Server Setup and Installation Guide
HP CONFIDENTIAL
Writer: Anna Roberts File Name: k-appa Regulatory Compliance Notices.doc
Codename: MoonStar Part Number: 293166-002 Last Saved On: 1/31/03 11:20 AM
Batteries, battery packs, and accumulators should not be disposed of
together with the general household waste. To forward them to recycling
or proper disposal, please use the public collection system or return
them to HP, an authorized HP Partner, or their agents.
Power Cords
The power cord set included in the server meets the requirements for use in the
country where the server was purchased. If this server is to be used in another
country, purchase a power cord that is approved for use in that country.
The power cord must be rated for the product and for the voltage and current marked
on the product's electrical ratings label. The voltage and current rating of the cord
should be greater than the voltage and current rating marked on the product. In
addition, the diameter of the wire must be a minimum of 1.00 mm² or 18 AWG, and
the length of the cord must be between 1.8 m (6 feet) and 3.6 m (12 feet). If you have
questions about the type of power cord to use, contact an authorized service provider.
IMPORTANT: Route power cords so that they will not be walked on or pinched by items
placed upon or against them. Pay particular attention to the plug, electrical outlet, and the point
where the cords exit from the product.
Mouse Compliance Statement
This device complies with Part 15 of the FCC Rules. Operation is subject to the
following two conditions: (1) this device may not cause harmful interference, and (2)
this device must accept any interference received, including interference that may
cause undesired operation.
To Next Page
Loading...
