Installing Hardware Options
3-30 HP ProLiant DL320 Generation 2 Server Setup and Installation Guide
HP CONFIDENTIAL
Writer: Anna Roberts File Name: d-ch3 Installing Hardware Options.doc
Codename: MoonStar Part Number: 293166-002 Last Saved On: 1/31/03 11:16 AM
8. Attach the SCSI cable to the SCSI module (1).
9. Install the hard drive (3). Refer to the “Installing ATA Hard Drives” section
earlier in this chapter.
10. Connect the SCSI cables (4) to the SCSI hard drives (3).
11. Install the center wall and PCI riser board assembly. Be sure that the cables run
through the opening in the center wall (2).
Figure 3-24: Cable configuration of the slotless SCSI
module
12. Install the access panel.
13. Configure any devices attached to the SCSI module before powering up the
server. Refer to the documentation that ships with the slotless SCSI module
upgrade kit.
External Mass Storage
This server supports external mass storage devices only through an optional PCI
expansion board. For detailed information, refer to the documentation that ships with
the optional PCI expansion board.
To Next Page
Loading...
