EasyManuals Logo

HP dx7400 - Microtower PC User Manual

HP dx7400 - Microtower PC
199 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #125 background imageLoading...
Page #125 background image
Battery
The battery that comes with your computer provides power to the real-time clock and has a lifetime of
about three years. When replacing the battery, use a battery equivalent to the battery originally installed
on the computer. The computer comes with a 3-volt lithium coin cell battery.
NOTE: The lifetime of the lithium battery can be extended by plugging the computer into a live AC wall
socket. The lithium battery is only used when the computer is NOT connected to AC power.
WARNING! This computer contains an internal lithium manganese dioxide battery. There is a risk of
fire and burns if the battery is not handled properly. To reduce the risk of personal injury:
Do not attempt to recharge the battery.
Do not expose to temperatures higher than 140°F (60°C).
Do not disassemble, crush, puncture, short external contacts, or dispose of in fire or water.
Replace the battery only with the HP spare designated for this product.
CAUTION: Before replacing the battery, it is important to back up the computer CMOS settings. When
the battery is removed or replaced, the CMOS settings will be cleared. Refer to the Computer Setup
(F10) Utility Guide for information on backing up the CMOS settings.
NOTE: HP encourages customers to recycle used electronic hardware, HP original print cartridges,
and rechargeable batteries. For more information about recycling programs, go to
http://www.hp.com/
recycle.
CAUTION: Static electricity can damage the electronic components of the computer or optional
equipment. Before beginning these procedures, ensure that you are discharged of static electricity by
briefly touching a grounded metal object.
1. Prepare the computer for disassembly (Preparation for Disassembly on page 87).
2. Remove the computer access panel (
Access Panel on page 88).
NOTE: It may be necessary to remove an expansion card to gain access to the battery.
3. Locate the battery and battery holder on the system board.
4. Carefully pull the cable bundle out of the way to access the battery.
5. Depending on the type of battery holder on your system board, complete the following instructions
to replace the battery:
Battery 115

Table of Contents

Other manuals for HP dx7400 - Microtower PC

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the HP dx7400 - Microtower PC and is the answer not in the manual?

HP dx7400 - Microtower PC Specifications

General IconGeneral
MemoryUp to 8 GB DDR2 SDRAM
AudioIntegrated High Definition Audio
Power Supply300W
ProcessorIntel Core 2 Duo, Pentium Dual-Core, or Celeron
StorageSATA Hard Drive
Optical DriveDVD-ROM, DVD+/-RW
GraphicsIntegrated Intel Graphics Media Accelerator 3100
NetworkingIntegrated Gigabit Ethernet
Expansion Slots1 PCI Express x16
Ports1 serial, 1 parallel, audio in/out
Operating SystemWindows XP Professional

Related product manuals