6-41
RADIUS Authentication, Authorization, and Accounting
Commands Authorization
Profile=IN OUT
Enums=Hp-Command-Exception-Types
[Hp-Command-Exception-Types]
0=PermitList
1=DenyList
2. Copy the hp.ini dictionary file to c:\program files\cisco acs 3.2\utils (or
the \utils directory wherever acs is installed).
3. From the command prompt execute the following command:
c:\Program files\CiscoSecure ACS v3.2\utils>
csutil -addudv 0 hp.ini
The zero (0) is the slot number. You will see some processing messages:
Adding or removing vendors requires ACS services to be
re-started. Please make sure regedit is not running as
it can prevent registry backup/restore operations.
Are you sure you want to proceed? (Y or N) y
Parsing [.\hp.ini] for addition at UDV slot [0]
Stopping any running services
Creating backup of current config
Adding Vendor [HP} added as [RADIUS (HP)]
Done
Checking new configuration...
New configuration OK
Re-starting stopped services
4. Start the registry editor (regedit) and browse to
HKEY_LOCAL_MACHINE\software\cisco\CiscoAAA v3.2\NAS Vendors
tree.
Cisco adds the entry into this tree for each custom vendor. The id is 100
+ the slot number used in the previous command (100 + 0, as it was added
in slot 0). Look in the key to verify the vendor name and id.
5. Go to:
HKEY_LOCAL_MACHINE\software\cisco\CiscoAAAv3.2\
CSRadius\ExtensionPoints\002\AssociatedWithVendors
To Next Page
Loading...
Need help?
General
