To Next Page

To Previous Page

11-37

Configuring Advanced Threat Protection

Using the Instrumentation Monitor

Viewing the Current Instrumentation Monitor

Configuration

The show instrumentation monitor configuration command displays the config-

ured thresholds for monitored parameters.

Figure 11-10. Viewing the Instrumentation Monitor Configuration

An alternate method of determining the current Instrumentation Monitor

configuration is to use the show run command. However, the show run com-

mand output does not display the threshold values for each limit set.

HP Switch# show instrumentation monitor configuration

PARAMETER LIMIT

------------------------- ---------------

mac-address-count 1000 (med)

ip-address-count 1000 (med)

system-resource-usage 50 (med)

system-delay 5 (high)

mac-moves/min 100 (med)

learn-discards/min 100 (med)

ip-port-scans/min 10 (med)

arp-requests/min 100 (low)

port-auth-failures/min 10 (med)

SNMP trap generation for alerts: enabled

Instrumentation monitoring log : enabled

Questions and Answers:

Need help?

Do you have a question about the HP E3800 Series and is the answer not in the manual?

HP E3800 Series Specifications

General