To Next Page

To Previous Page

10-117

IPv4 Access Control Lists (ACLs)

Enable ACL “Deny” Logging

Monitoring Static ACL Performance

ACL statistics counters provide a means for monitoring ACL performance by

using counters to display the current number of matches the switch has

detected for each ACE in an ACL assigned to a switch interface. This can help,

for example, to determine whether a particular traffic type is being filtered by

the intended ACE in an assigned list, or if traffic from a particular device or

network is being filtered as intended.

Note This section describes the command for monitoring static ACL performance.

To monitor RADIUS-assigned ACL performance, use either of the following

commands:

show access-list radius < all | port-list >

show port-access < authenticator | mac-based | web-based > clients

< port-list > detailed

Refer to “Displaying the Current RADIUS-Assigned ACL Activity on the

Switch” on page 7-37.

Questions and Answers:

Need help?

Do you have a question about the HP E3800 Series and is the answer not in the manual?

HP E3800 Series Specifications

General