To Next Page

To Previous Page

8-17

Configuring Secure Shell (SSH)

Configuring the Switch for SSH Operation

Syntax: [no] ip ssh

Enables or disables SSH on the switch.

[cipher <cipher-type>]

Specify a cipher type to use for connection.

Valid types are:

• aes128-cbc

• 3des-cbc

• aes192-cbc

• aes256-cbc

• rijndael-cbc@lysator.liu.se

• aes128-ctr

• aes192-ctr

• aes256-ctr

Default: All cipher types are available.

Use the no form of the command to disable a cipher type.

[filetransfer]

Enable/disable secure file transfer capability. SCP and SFTP

secure file transfer will not function unless SSH is also

enabled.

[ip-version <4|6|4or6>]

Select the IP mode to run in. The mode “ip-version 4” only

accepts connections from IPv4 clients. The mode “ip-version

6” only accepts connections from IPv6 clients. The mode “ip-

version 4or6” accepts connections from both IPv4 and IPv6

clients.

Default: ip-version 4or6

Questions and Answers:

Need help?

Do you have a question about the HP E3800 Series and is the answer not in the manual?

HP E3800 Series Specifications

General