2-3
Configuring Username and Password Security
Overview
Notes The manager and operator passwords and (optional) usernames control
access to the menu interface, CLI, and WebAgent.
If you configure only a Manager password (with no Operator password), and
in a later session the Manager password is not entered correctly in response
to a prompt from the switch, then the switch does not allow management
access for that session.
If the switch has a password for both the Manager and Operator levels, and
neither is entered correctly in response to the switch’s password prompt, then
the switch does not allow management access for that session.
Passwords are case-sensitive.
When configuring an operator or manager password a message will appear
indicating that (USB) autorun has been disabled. For more information on the
autorun feature, refer to the Appendix A on “File Transfers” in the Manage-
ment and Configuration Guide for your switch.
Caution If the switch has neither a Manager nor an Operator password, anyone
having access to the switch through either Telnet, the serial port, or the
WebAgent can access the switch with full manager privileges. Also, if you
configure only an Operator password, entering the Operator password
enables full manager privileges.
The rest of this chapter covers how to:
■ Set passwords
■ Delete passwords
■ Recover from a lost password
■ Maintain front-panel security
To Next Page
Loading...
Need help?
General