To Next Page

To Previous Page

13-59

Configuring Port-Based and User-Based Access Control (802.1X)

Displaying 802.1X Configuration, Statistics, and Counters

Figure 13-13.Example of show port-access authenticator statistics Command

Syntax: show port-access authenticator statistics [port-list]

Displays statistical information for all switch ports or spec-

ified ports that are enabled as 802.1X authenticators, includ-

ing:

• Whether port-access authentication is enabled

• Whether RADIUS-assigned dynamic VLANs are supported

• 802.1X supplicant’s MAC address as determined by the

content of the last EAPOL frame received on the port

• 802.1X traffic statistics from received and transmitted

packets

802.1X configuration information for ports that are not

enabled as an 802.1X authenticators is not displayed.

HP Switch(config)# show port-access authenticator statistics

Port Access Authenticator Statistics

Port-access authenticator activated [No] : Yes

Allow RADIUS-assigned dynamic (GVRP) VLANs [No] : No

Source TX TX RX RX RX RX RX

Port MAC address ReqId Req Start Logoff RespId Resp Errors

---- ------------- ------ ----- ------ ------- ------- ----- -------

001560-b3ea48 1 0 0 0 0 0 0

Questions and Answers:

Need help?

Do you have a question about the HP E3800 Series and is the answer not in the manual?

HP E3800 Series Specifications

General