Remove the solid-state drive:
1. Release the grounding tape (1) that secures the solid-state drive shield to the memory module shield.
2. Use the tab (2) on the solid-state drive shield to lift and remove the shield (3) from the computer.
The solid-state drive shield is available using spare part number N18250-001.
When installing the solid-state drive shield, be sure that the edges of the shield t into all the clips (4) that
are built into the system board.
3. Remove the Phillips M2.0 × 2.5 screw (1) that secures the solid-state drive to the system board.
4. Pull the solid-state drive (2) away from the socket to remove it.
To install the solid-state drive, reverse the removal procedure.
NOTE: Solid-state drives are designed with a notch to prevent incorrect insertion.
WLAN module
To remove the WLAN module, use this procedure and illustration.
WLAN module
47
To Next Page
Loading...
