2. Detach the NFC module (2) from the top cover/keyboard. (The NFC module is attached to the top cover/
keyboard with double-sided adhesive.)
3. Remove the NFC module.
To install theNFC module, reverse the removal procedure.
Touchpad cable
To remove the touchpad cable, use this procedure and illustration.
NOTE: The touchpad cable is included in the Cable Kit, spare part number N18760-001.
Before removing thetouchpad cable, follow these steps:
1. Prepare the computer for disassembly (see Preparation for disassembly on page 39).
2. Remove the bottom cover (see Bottom cover on page 39).
3. Remove the battery (see Battery on page 41).
Remove the touchpad cable:
1. Release the ZIF connector (1) to which the touchpad cable is connected, and then disconnect the touchpad
cable from the system board.
2. Release the ZIF connector (2) to which the touchpad cable is connected, and then disconnect the touchpad
cable from the touchpad.
Touchpad cable 69
To Next Page
Loading...
