3. Detach the NFC module cable (3) from the top cover/keyboard and touchpad. (The NFC module cable is
attached to the top cover/keyboard and touchpad with double-sided adhesive.)
4. Remove the NFC module cable.
To install theNFC module cable, reverse the removal procedure.
NFC module antenna
To remove the NFC module antenna, use this procedure and illustration.
NOTE: The NFC module antenna is included in the Antenna Kit, spare part number N16105-001.
Before removing theNFC module antenna, follow these steps:
1. Prepare the computer for disassembly (see Preparation for disassembly on page 39).
2. Remove the bottom cover (see Bottom cover on page 39).
3. Remove the battery (see Battery on page 41).
Remove the NFC module antenna:
1. Release the ZIF connector (1) to which the NFC module antenna is connected, and then disconnect the NFC
module antenna from the NFC module.
NFC module antenna 67
To Next Page
Loading...
