3. Detach the touchpad cable (3) from the top cover/keyboard and touchpad. (The touchpad cable is attached
to the top cover/keyboard and touchpad with double-sided adhesive.)
4. Remove the touchpad cable.
To install the touchpad cable, reverse the removal procedure.
Touchpad
To remove the touchpad, use this procedure and illustration.
Table 5-12
Touchpad descriptions and part numbers
Description Spare part number
Touchpad:
NOTE: The touchpad spare part kit does not include the touchpad cable. The touchpad cable is available using spare part number
N18760-001
With NFC module antenna N15436-001
Without NFC module antenna N09033-001
Before removing the touchpad, follow these steps:
1. Prepare the computer for disassembly (see Preparation for disassembly on page 39).
2. Remove the bottom cover (see Bottom cover on page 39).
3. Remove the battery (see Battery on page 41).
4. Remove the touchpad cable (see Touchpad cable on page 69).
Remove the touchpad:
1. Release the ZIF connector (1) to which the NFC module antenna cable is connected, and then disconnect the
NFC module antenna cable from the NFC module.
70
Chapter 5Removal and replacement procedures for authorized service provider parts
To Next Page
Loading...
