2. Detach the NFC module antenna (2) from the top cover/keyboard and touchpad. (The NFC module antenna
is attached to the top cover/keyboard and touchpad with double-sided adhesive.)
3. Remove the NFC module antenna.
To install theNFC module antenna, reverse the removal procedure.
NFC module
To remove the NFC module, use this procedure and illustration.
Table 5-11
NFC module description and part number
Description Spare part number
NFC module
NOTE: The NFC module spare part kit does not include the NFC module antenna or the NFC module cable.
The NFC module antenna is included in the Antenna Kit, spare part number N16105-001. The NFC module
cable is included in the Cable Kit, spare part number N18760-001.
M08706-001
NFC module antenna: The NFC module antenna is included in the Antenna Kit, spare part number N16105-001
NFC module cable: The NFC module cable is included in the Cable Kit, spare part number N18760-001.
Before removing theNFC module, follow these steps:
1. Prepare the computer for disassembly (see Preparation for disassembly on page 39).
2. Remove the bottom cover (see Bottom cover on page 39).
3. Remove the battery (see Battery on page 41).
4. Remove the NFC module cable (see NFC module cable on page 66).
Remove the NFC module:
1. Release the ZIF connector (1) to which the NFC module antenna cable is connected, and then disconnect the
NFC module antenna cable from the NFC module.
68
Chapter 5Removal and replacement procedures for authorized service provider parts
To Next Page
Loading...
