3. Remove the connector board cable (3) from the computer.
To install the connector board cable, reverse the removal procedure.
Audio jack cable
To remove the audio jack cable, use this procedure and illustration.
NOTE: The audio jack cable is included in the Cable Kit, spare part number N18760-001.
Before removing the audio jack cable, follow these steps:
1. Prepare the computer for disassembly (see Preparation for disassembly on page 39).
2. Remove the bottom cover (see Bottom cover on page 39).
3. Disconnect the battery cable from the system board (see Battery on page 41).
Remove the audio jack cable:
1. Release the ZIF connector (1) to which the audio jack cable is connected, and then disconnect the cable from
the system board.
2. Remove the Phillips M2.0 × 4.7 screw (2) that secures the audio jack to the computer.
Audio jack cable 51
To Next Page
Loading...
