j. Disconnect the display panel cable (5) from the display panel.
k. Remove the display panel.
The display panel is available using the following spare part numbers:
● M99947-005: 35.6 cm (14.0 in), LCD, WUXGA (1920 × 1200), antiglare, LED, UWVA, 45% CG, eDP
without PSR, bent, TOP display panel; typical brightness: 250 nits
● N99948-005: 35.6 cm (14.0 in), LCD, WUXGA (1920 × 1200), antiglare, LBL, UWVA, 45% CG, eDP
1.4 + PSR, bent, non-TOP display panel; typical brightness: 250 nits
● N99949-005: 35.6 cm (14.0 in), LCD, WUXGA (1920 × 1200), antiglare, LBL, UWVA, 45% CG, eDP
1.3 + PSR, bent, non-TOP display panel; typical brightness: 250 nits
● M99946-005: 35.6 cm (14.0 in), LCD, WUXGA (1920 × 1200), antiglare, LED, UWVA, 45% CG, eDP
without PSR, bent, non-TOP display panel; typical brightness: 250 nits
15. If you need to remove the webcam module cable:
a. Remove the display assembly.
b. Remove the display bezel.
c. Remove the hinge cover.
d. Remove the hinges.
e. Remove the display panel.
f. Release the ZIF connector (1) to which the webcam module cable is connected, and then disconnect
the webcam module cable from the RGB hub board.
g. Release the ZIF connector (2) to which the webcam module cable is connected, and then disconnect
the webcam module cable from the webcam module.
Display assembly
61
To Next Page
Loading...
