d. Disconnect the tube set.
e. Disconnect all peripheral cables from the servers and chassis.
2. Open the bezel ear latch.
3. Loosen the bezel ear screw.
4. Use the bezel ear latches to pull the chassis out of the rack until the rack rail lock is engaged.
Remove the chassis from the rack
WARNING: To reduce the risk of personal injury or equipment damage, be sure that the rack is adequately
stabilized before extending a component from the rack.
Prerequisites
• Before you perform this procedure, make sure that you have a T-25 Torx screwdriver available.
• Before you perform this procedure, review the:
◦
Rack warnings and cautions
◦ Server warnings and cautions
• A fully populated chassis is heavy. Hewlett Packard Enterprise recommends removing the external chassis
components before removing the chassis from the rack.
Procedure
1. Power down the servers.
2. Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the chassis.
Removal and replacement procedures
29
To Next Page
Loading...
