12. Place the chassis on a sturdy, level surface.
Remove the access panel
WARNING: To reduce the risk of personal injury from hot surfaces, allow the drives and the internal system
components to cool before touching them.
CAUTION: To prevent damage to electrical components, take the appropriate anti-static precautions before
beginning any installation, removal, or replacement procedure. Improper grounding can cause electrostatic
discharge.
Procedure
1.
Power down the servers.
2.
Remove all power:
a.
Disconnect each power cord from the power source.
b.
Disconnect each power cord from the chassis.
3.
If installed,
disconnect the tube set.
4. Disconnect all peripheral cables from the servers and chassis.
5. Do one of the following:
•
Extend the chassis from the rack.
• Remove the chassis from the rack.
6. Remove the access panel:
Removal and replacement procedures
31
To Next Page
Loading...
