HP HPE Apollo 2000 Gen10 Plus User Manual

To replace the component, reverse the removal procedure.
Removing and replacing the PIB
CAUTION: Before replacing a DIMM, expansion card, or other similar PCA components due to a perceived hardware
error, make sure first that the component is firmly seated in the slot. Do not bend or flex circuit boards when
reseating components.
Prerequisites
Before you perform this procedure, make sure that you have the following items available:
• T-10 Torx screwdriver
• T-15 Torx screwdriver
Procedure
1.
Power down the servers.
2.
Remove all power:
a.
Disconnect each power cord from the power source.
b.
Disconnect each power cord from the chassis.
3.
If installed,
disconnect the tube set.
4.
Disconnect all peripheral cables from the servers and chassis.
5.
Remove the chassis from the rack.
6.
Remove the access panel.
7.
Remove the PDB cover screws (callout 1), and then remove the cover (callout 2).
8. If installed, remove the energy pack.
9. Remove the PIB assembly from the PDB.
Removal and replacement procedures
54

HP HPE Apollo 2000 Gen10 Plus Specifications

General

Brand	HP
Model	HPE Apollo 2000 Gen10 Plus
Category	Measuring Instruments
Language	English