To replace the component, reverse the removal procedure.
Removing and replacing a fan
CAUTION: To prevent improper cooling and thermal damage, do not operate the chassis unless all bays are
populated with a component or a blank.
Procedure
1.
Power down the servers.
2.
Remove all power:
a.
Disconnect each power cord from the power source.
b.
Disconnect each power cord from the chassis.
3.
If installed,
disconnect the tube set.
4.
Disconnect all peripheral cables from the servers and chassis.
5.
Do one of the following:
•
Extend the chassis from the rack.
• Remove the chassis from the rack.
6. Remove the access panel.
7. Grip both sides of the fan, and then lift the fan from the bay.
Removal and replacement procedures
40
To Next Page
Loading...
