IMPORTANT: To enable SmartCache or CacheCade in a P-class type-p Smart Array controller, you must:
• Connect the controller backup power cable to the controller backup power connector on the system or
riser board.
• Connect the energy pack cable to the energy pack connector on the system board.
17.
Connect storage devices to the controller.
For cabling information, see the server user guide.
18.
Install the HPE Smart Storage Battery or HPE Smart Storage Hybrid Capacitor.
19.
Reinstall the riser.
20.
Connect peripheral devices to the server.
21.
Connect the power cord to the server.
22.
Connect the power cord to the power source.
23.
Power up all peripheral devices.
24.
Power up the server.
Installing the operating system with the HPE Smart Array MR Gen10 P824i-p controller
driver
Prerequisites
Ensure that you have the HPE Smart Array MR Gen10 P824i-p controller driver available. Obtain it by extracting it from
the SPP (
https://www.hpe.com/servers/spp) or by downloading it from the Hewlett Packard Enterprise Support website
https://www.support.hpe.com.
Hardware options installation
116
To Next Page
Loading...
