10. Connect any required internal or external cables to the expansion board.
11.
Install the primary PCI riser cage.
12.
Install the access panel.
13.
Install the server in the rack.
14.
Connect each power cord to the server.
15.
Connect each power cord to the power source.
16.
Power up the server.
Installing an accelerator or GPU in the primary riser cage
Use these instructions to install accelerator options, including GPUs, in the server.
Prerequisites
This option requires the standard primary PCI riser cage.
Before installing this option, be sure that the power supplies support the installation of this option. For more information,
see the Hewlett Packard Enterprise Configurator website (http://www.hpe.com/info/SimpleConfigurator).
In addition, be sure that you have the following items:
• The components included with the hardware option kit.
• HPE Gen10 CPU1 Cable Kit (if installing a high-powered GPU kit) for your server.
Procedure
1. Observe the following alerts:
WARNING: To reduce the risk of personal injury from hot surfaces, allow the drives and the internal system
components to cool before touching them.
Hardware options installation 93
To Next Page
Loading...
