Installing the 4 LFF display port/USB module
Prerequisites
Before installing this option, be sure you have the following:
• The components included with the hardware option kit
• T-10 Torx screwdriver
Procedure
1.
Power down the server (
Power down the server).
2.
Remove all power:
a.
Disconnect each power cord from the power source.
b.
Disconnect each power cord from the server.
3.
Do one of the following:
a. Extend the server from the rack (
Extend the server from the rack).
b. Remove the server from the rack (Remove the server from the rack).
4. Remove the access panel (
Remove the access panel).
5. Using a Torx T-10 screwdriver, remove the 4 LFF display port/USB blank.
Hardware options installation
128
To Next Page
Loading...
