9. Install the optional riser board in the riser cage.
10.
Install the following, as needed:
• Expansion boards (Installing an expansion board in the primary riser cage)
• GPU (
Installing an accelerator or GPU in the primary riser cage)
• Controllers (Smart Array controller options)
11.
Install the riser cage (Install the primary PCI riser cage).
12.
Install the access panel (
Install the access panel).
13.
Install the server in the rack.
14.
Connect each power cord to the server.
15.
Connect each power cord to the power source.
16.
Power up the server (
Power up the server).
Installing the SATA M.22280 riser option
Prerequisites
Before installing this option, be sure that you have the following:
• The components included with the hardware option kit
• Up to two 2280 form factor M.2 drives
• T-15 Torx screwdriver
Hardware options installation
89
To Next Page
Loading...
