HP HPE ProLiant DX360 Gen10 - Remove the Hot-Plug Fan

The access panel slides to a closed position.
3. Tighten the security screw on the latch, if needed.
Remove the hot-plug fan
Procedure
1. Observe the following alert:
IMPORTANT: After removing a high-performance (dual-rotor) fan, install or replace the fan within 60 seconds.
Otherwise, the server will shut down gracefully.
2. Do one of the following:
a. Extend the server from the rack (Extend the server from the rack).
b. Remove the server from the rack (Remove the server from the rack).
3. Remove the access panel (Remove the access panel).
4.
Remove the fan.
Operations
38