9. Install the access panel (Install the access panel).
10. Install the server in the rack.
11.
Connect each power cord to the server.
12.
Connect each power cord to the power source.
13.
Power up the server.
Installing the rear drive riser cage option
The rear drive riser cage option supports low-profile PCI riser options in slot 2.
Prerequisites
Before installing this option, be sure that you have the following:
• The components included with the hardware option kit.
• T-10 and T-15 Torx screwdriver.
• 1 SFF drive, 2 uFF M.2 drives, or blanks.
Procedure
1.
Power down the server.
2. Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
3. Do one of the following:
Hardware options installation
84
To Next Page
Loading...
