11. Install the primary PCI riser cage.
12. Install the access panel (
Install the access panel).
13.
Install the server in the rack.
14.
Connect each power cord to the server.
15.
Connect each power cord to the power source.
16.
Power up the server.
Secondary PCI riser options
Installing a secondary full-height PCI riser cage option
When installed, this riser cage supports full-height, 3/4-length expansion boards up to 95". PCIe3 slot 2 is no longer
available.
Prerequisites
This option requires a dual processor configuration.
Before installing this option, be sure you have the following:
• The components included with the hardware option kit
• Any expansion boards or controllers you plan to install
• T-10 Torx screwdriver
• T-15 Torx screwdriver
Procedure
1. Power down the server (Power down the server).
2. Remove all power:
Hardware options installation
95
To Next Page
Loading...
