a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
3. Do one of the following:
a. Extend the server from the rack (Extend the server from the rack).
b. Remove the server from the rack (Remove the server from the rack).
4. Remove the access panel (Remove the access panel).
5. Remove the primary PCI riser cage (Remove the primary PCI riser cage).
6. Use a T-10 Torx screwdriver to remove the slot 2 bracket from the primary riser cage.
7.
If installed, remove the low-profile riser cage.
8. Lift and remove the secondary riser cage latch.
Hardware options installation
96
To Next Page
Loading...
