10. Install the access panel (Install the access panel).
11. Install the server in the rack.
12.
Connect each power cord to the server.
13.
Connect each power cord to the power source.
14.
Power up the server.
15.
Install drives.
Installing a 2 SFF NVMe drive cage option
Prerequisites
Before installing this option, be sure that you have the following:
• The components included with the hardware option kit
• T-10 Torx screwdriver
• T-15 Torx screwdriver
• Additional cables, as needed. For more information, see
SFF cables.
• NVMe drives
For more information, contact a Hewlett Packard Enterprise authorized reseller.
Procedure
1. Back up all server data.
2.
Power down the server.
3. Remove all power:
Hardware options installation
75
To Next Page
Loading...
