HP HPE ProLiant DX360 Gen10

To Next Page

To Previous Page

8. Route and connect the data cable.

Route and connect the power cable.

Hardware options installation

Main Page

Table of Contents3
Component Identification8
Front Panel Components8
Front Panel Leds and Buttons10
UID Button Functionality12
Front Panel LED Power Fault Codes12
Systems Insight Display Leds12
Systems Insight Display Combined LED Descriptions14
Rear Panel Components16
Rear Panel Leds16
System Board Components18
System Maintenance Switch Descriptions19
NMI Functionality19
DIMM Slot Locations19
DIMM Label Identification20
NVDIMM Identification21
NVDIMM LED Identification23
Intel Optane Persistent Memory 100 Series for HPE Label Identification24
Processor, Heatsink, and Socket Components25
Device Numbers25
Hot-Plug Drive LED Definitions27
Smart Carrier Nvme (SCN) Drive LED Definitions28
Uff Drive Components and Leds29
Hot-Plug Fans30
HPE Smart Array P824I-P MR Gen10 Controller32
HPE Infiniband Hdr/Ethernet 940QSFP 56X16 Adapter Leds33
DSC-25 2-Port SFP28 Card Ports and Leds33
Operations36
Power up the Server36
Power down the Server36
Extend the Server from the Rack36
Remove the Server from the Rack37
Remove the Access Panel37
Install the Access Panel37
Remove the Hot-Plug Fan38
Remove the Primary PCI Riser Cage39
Install the Primary PCI Riser Cage40
Remove the Secondary PCI Riser Cage41
Install the Secondary PCI Riser Cage42
Remove the 8 SFF Drive Backplane43
Release the Cable Management Arm43
Setup45
Optional Service45
Optimum Environment45
Space and Airflow Requirements45
Temperature Requirements46
Power Requirements46
Electrical Grounding Requirements47
Connecting a DC Power Cable to a DC Power Source47
Server Warnings and Cautions48
Rack Warnings49
Identifying the Contents of the Server Shipping Carton49
Installing Hardware Options50
Installing the Server into the Rack50
Operating System51
Installing the Operating System with Intelligent Provisioning51
Selecting Boot Options in UEFI Boot Mode51
Selecting Boot Options52
Registering the Server52
Hardware Options Installation53
Hewlett Packard Enterprise Product Quickspecs53
Introduction53
Installing a Redundant Hot-Plug Power Supply53
Memory Options54
DIMM and NVDIMM Population Information54
DIMM-Processor Compatibility55
HPE Smartmemory Speed Information55
Installing a DIMM55
HPE 16GB NVDIMM Option56
Intel Optane Persistent Memory 100 Series for HPE60
Installing a High-Performance Fan63
Drive Options65
Hot-Plug Drive Guidelines65
Removing the Hard Drive Blank65
Installing a Hot-Plug SAS or SATA Drive66
Removing a Hot-Plug SAS or SATA Hard Drive67
Installing the Nvme Drives67
Removing and Replacing an Nvme Drive69
Installing a Uff Drive and SCM Drive Carrier69
Removing and Replacing a Uff Drive70
Installing an 8 SFF Optical Drive71
Universal Media Bay Options72
Installing a 2 SFF SAS/SATA Drive Cage72
Installing a 2 SFF Nvme Drive Cage Option75
Installing a 2 SFF HPE Smart Carrier M.2 (SCM) Drive Cage78
Installing an 8 SFF Display Port/Usb/Optical Blank Option80
Installing the 4 LFF Optical Drive Option82
Installing the Rear Drive Riser Cage Option84
Primary PCI Riser Cage Options87
Installing an Optional Primary PCI Riser Board88
Installing the SATA M.2 2280 Riser Option89
Installing an Expansion Board in the Primary Riser Cage91
Installing an Accelerator or GPU in the Primary Riser Cage93
Secondary PCI Riser Options95
Installing a Secondary Full-Height PCI Riser Cage Option95
Installing a Secondary Low-Profile Pcie Slot Riser Cage Option98
Installing an Expansion Board in the Secondary Riser Cage100
Installing an Accelerator or GPU in the Secondary Riser Cage102
Smart Array Controller Options105
Installing an HPE Smart Array P408I-A SR Gen10 Controller Option105
Installing an HPE Smart Array P408I-P SR Gen10 Controller Option109
Installing an HPE Smart Array P816I-A SR Gen10 Controller Option112
Installing an HPE Smart Array P824I-P MR Gen10 Controller in a Configured Server115
Installing the Operating System with the HPE Smart Array MR Gen10 P824I-P Controller Driver116
Processor and Heatsink Options117
Installing a Processor Heatsink Assembly117
Installing a High Performance Heatsink119
Processor, Heatsink, and Socket Components123
Installing the Systems Insight Display Power Module124
Installing the 4 LFF Display Port/Usb Module128
Installing the Serial Cable Option130
Installing the Chassis Intrusion Detection Switch Option132
Installing the Flexiblelom Option134
Energy Pack Options135
HPE Smart Storage Battery135
HPE Smart Storage Hybrid Capacitor136
Minimum Firmware Versions136
Energy Pack Option Configurations136
HPE Trusted Platform Module 2.0 Gen10 Option141
Overview141
HPE Trusted Platform Module 2.0 Guidelines142
Installing and Enabling the HPE TPM 2.0 Gen10 Option142
Cabling147
Cabling Overview147
SFF Cables147
SFF Backplane to P824I-P Controller148
SFF Backplane to a P408I-A/P816I-A Controller149
SFF Backplane to P816I-A Controller150
10 SFF Nvme Backplane to Nvme Riser150
SFF Nvme Backplane to Primary Riser151
SFF Rear Backplane to System Board SATA151
10 SFF Backplane to P408I-A Controller152
Additional SFF Cabling152
LFF Cables152
LFF Backplane to P408I-A Controller153
Additional LFF Cabling153
Software and Configuration Utilities154
Server Mode154
All Nutanix Product Documentation154
Product Quickspecs154
Active Health System Viewer154
Active Health System155
HPE Ilo 5156
Ilo Federation156
Ilo Service Port156
Ilo Restful API157
Restful Interface Tool157
Ilo Amplifier Pack157
HPE Apollo Platform Manager Overview158
HPE Insight Cluster Management Utility158
Integrated Management Log159
Intelligent Provisioning159
Intelligent Provisioning Operation159
Management Security160
Scripting Toolkit for Windows and Linux160
UEFI System Utilities161
Selecting the Boot Mode161
Secure Boot162
Launching the Embedded UEFI Shell162
HPE Smart Storage Administrator163
HPE MR Storage Administrator164
HPE Infosight for Servers164
Storcli165
USB Support165
External USB Functionality165
Redundant ROM Support165
Safety and Security Benefits165
Keeping the System Current165
Updating Firmware or System ROM165
Drivers168
Software and Firmware168
Operating System Version Support168
HPE Pointnext Portfolio168
Proactive Notifications169
Troubleshooting170
Troubleshooting Resources170
Removing and Replacing the System Battery171
Specifications173
Environmental Specifications173
Server Specifications173
Power Supply Specifications174
HPE 500W Flex Slot Platinum Hot-Plug Low Halogen Power Supply174
HPE 800W Flex Slot Platinum Hot-Plug Low Halogen Power Supply175
HPE 800W Flex Slot Titanium Hot-Plug Low Halogen Power Supply176
HPE 800W Flex Slot Universal Hot-Plug Low Halogen Power Supply177
HPE 800W Flex Slot -48VDC Hot-Plug Low Halogen Power Supply178
HPE 1600 W Flex Slot Platinum Hot-Plug Low Halogen Power Supply179
Hot-Plug Power Supply Calculations180
Websites181
Support and Other Resources182
Accessing Hewlett Packard Enterprise Support182
Accessing Updates182
Remote Support183
Warranty Information183

HP HPE ProLiant DX360 Gen10 - Page 74

Table of Contents

Related product manuals