• The components included with the hardware option kit
• T-10 Torx screwdriver
• Additional cables, as needed. For more information, see SFF cables.
• 2 SFF SAS or SATA drives or blanks
For more information, contact a Hewlett Packard Enterprise authorized reseller.
Procedure
1. Back up all server data.
2. Power down the server.
3. Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
4. Do one of the following:
a.
Extend the server from the rack.
b.
Remove the server from the rack.
5.
Remove the access panel.
6.
Remove the universal media bay blank.
7. Install the 2 SFF SAS/SATA drive cage.
Hardware options installation
73
To Next Page
Loading...
