4. Insert the power supply into the power supply bay until it clicks into place.
5.
Connect the power cord to the power supply.
6.
Route the power cord. Use best practices when routing power cords and other cables. A cable management arm is
available to help with routing. To obtain a cable management arm, contact a Hewlett Packard Enterprise authorized
reseller.
7.
Connect the power cord to the AC power source.
8.
Be sure that the power supply LED is green (
Rear panel LEDs).
Memory options
IMPORTANT: This server does not support mixing LRDIMMs and RDIMMs. Attempting to mix any combination of
these DIMMs can cause the server to halt during BIOS initialization. All memory installed in the server must be of
the same type.
DIMM and NVDIMM population information
For specific DIMM and NVDIMM population information, see the DIMM population guidelines on the Hewlett Packard
Enterprise website (https://www.hpe.com/docs/memory-population-rules).
Hardware options installation
54
To Next Page
Loading...
