a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
4. Do one of the following:
a. Extend the server from the rack.
b. Remove the server from the rack.
5. Remove the access panel.
6. Use a T-10 Torx screwdriver to remove the universal media bay blank.
7.
Use a T-10 Torx screwdriver to install the 2 SFF NVMe drive cage.
8. Remove the primary PCI riser cage (Remove the primary PCI riser cage).
9. Use a T-15 Torx screwdriver to remove the existing riser board.
Hardware options installation
76
To Next Page
Loading...
