Installing an energy pack in the 10 SFF SAS/SATA/NVMe Combo backplane configuration
Prerequisites
The energy pack must be installed in this orientation when the 10 SFF SAS/SATA/NVMe Combo backplane is installed.
Procedure
1. Power down the server (Power down the server).
2. Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
3. Do one of the following:
a.
Extend the server from the rack.
b.
Remove the server from the rack.
4.
Remove the access panel.
5.
Remove the right retainer. Set aside.
6. Slide the energy pack into the left retainer, and then install the right retainer.
Hardware options installation
137
To Next Page
Loading...
