CAUTION: If the TPM is removed from the original server and powered up on a dierent server, data stored in
the TPM including keys will be erased.
CAUTION: The TPM is keyed to install only in the orientation shown. Any attempt to install the TPM in a
dierent orientation might result in damage to the TPM or system board.
2. Align the TPM board with the key on the connector, and then install the TPM board. To seat the board, press the TPM
board firmly into the connector. To locate the TPM connector on the system board, see the server label on the access
panel.
3.
Install the TPM cover:
a.
Line up the tabs on the cover with the openings on either side of the TPM connector.
b.
To snap the cover into place, firmly press straight down on the middle of the cover.
4. Proceed to Preparing the server for operation.
Hardware options installation
144
To Next Page
Loading...
